All FAQs (1827 total: showing 1321-1340)
- What kind of gases need to be ordered to zero and span an analyzer?
- If the sonic temperature is reading a couple degrees different from the IRGASON™ or EC150 temperature probe, is that a problem?
- When should the enhanced barometer be selected over the basic barometer for the EC150 or IRGASON™?
- Can a sensor cable be shortened?
- Can a sensor cable be replaced?
- How often should the CHP1-L be calibrated?
- How often should the CHP1-L window be cleaned?
- Does the CHP1-L have an internal temperature sensor?
- What type of tracker can be used with the CHP1-L?
- Is a two-axis tracker needed for the CHP1-L?
- Can the output signal from a CHP1-L be negative?
- Does the CHP1-L require a power supply?
- How does the CHP1-L work?
- What type of sensor is the CHP1-L, and what does it measure?
- Can the lead for the CMP21 be ordered in a length of 300 ft? If so, is this a single, continuous cable, or are there two different cables that are joined together?
- Do the CMP6, CMP11, and CMP21 require a power supply?
- To create a network of accurate solar irradiance measurements, do all of the stations need a Class A (secondary standard) pyranometer?
- Are the CMP6, CMP11, and CMP21 similar in accuracy and measurements?
- How can measurements be made using a 107, 108, or 109 temperature sensor/probe with a measurement device other than a Campbell Scientific data logger?
- For the 107, 108, and 109 temperature sensors/probes, where within the white cylinder is the thermistor actually located?
Previous
Next