FAQs Frequently Asked Questions About our Products and Solutions

Are the CR800 and CR1000 capable of being programmed through a CD100 or CR1000KD without the use of computer software?

Although it is recommended to use software such as Short Cut for programming, the CR800-series, CR1000, and CR3000 dataloggers can be programmed with the CD100, CR1000KD, or integrated keypads. The keypad can be used to create new programs or edit programs that already exist in the data logger memory.

From the CD100 or CR1000KD home screen, follow these steps to get started:

1. Press Enter. 
2. Select File and press Enter. 
3. Select either New or Edit. 
• To modify an existing instruction, select the instruction, and press Enter. 
• To add a new instruction, press Ins, and select Instruction.

Similar FAQs

• Can the CR800, CR850, CR1000, or CR3000 upload to an FTP site on scheduled intervals?
• How can LoggerNet be upgraded to LoggerNet Admin?
• To communicate with a CR1000 or CR3000 by TCP/IP using an NL120 or NL240, is it necessary for the data logger to have a fixed IP address?
• How to connect to a datalogger through an RS232 port? (For CR800, CR1000X and CR3000)
• How much does a typical system cost?
• The CR1000/CR3000 wiring panel shows four serial I/O ports on C1 to C8. Do these serial I/O ports provide the same functionality as the SDM-SIO4 module did on a CR10X or CR23X datalogger?
• How many control ports are available on a CR1000?