FAQs Frequently Asked Questions About our Products and Solutions

Submit an enquiry Submit an enquiry

How can variables be saved so that they are available for use after the data logger power has been removed and the data logger has been powered up again?

Use the PreserveVariables() instruction to ensure that all variables reflect the last known value if the data logger experiences power loss.

This was helpful

FAQs Home

Similar FAQs

How much does a typical system cost?
How can LoggerNet be upgraded to LoggerNet Admin?
Can the CR800, CR850, CR1000, or CR3000 upload to an FTP site on scheduled intervals?
To communicate with a CR1000 or CR3000 by TCP/IP using an NL120 or NL240, is it necessary for the data logger to have a fixed IP address?
Is it possible for LoggerNet to collect data from a data logger and then SFTP it to a server?
The CR1000/CR3000 wiring panel shows four serial I/O ports on C1 to C8. Do these serial I/O ports provide the same functionality as the SDM-SIO4 module did on a CR10X or CR23X datalogger?
How many sensors can a datalogger measure?