FAQs Frequently Asked Questions About our Products and Solutions

Where can processor usage information be found?

For the CR1000 datalogger, the Status table, accessed from the CR1000KD or LoggerNet (version 4) Connect screen, Station Status button, has some statistics that may be useful. Refer to “ProcessTime,” “MaxProcTime,” “MeasureTime,” and “MeasureOps” in Appendix B of the CR1000 Operator’s Manual. 

FAQs Home

Search

Similar FAQs

• To communicate with a CR1000 or CR3000 by TCP/IP using an NL120 or NL240, is it necessary for the data logger to have a fixed IP address?
• How many control ports are available on a CR1000?
• How much does a typical system cost?
• If the message “Clock check started” is followed by the message “Clock check failed,” what does this mean?
• Can the CR1000 measure 4 to 20 mA signals?
• If a device or sensor is not available for selection in the Short Cut program, how can it be added?
• What is the TDF file?