FAQs Frequently Asked Questions About our Products and Solutions

Submit an enquiry Submit an enquiry

Which ports on the CR5000 can be used to collect data from serial sensors?

The CR5000 does not natively support communication with serial sensors; however, SDM-SIO1 modules can be added to collect data from serial sensors.

This was helpful

FAQs Home

Similar FAQs

How can LoggerNet be upgraded to LoggerNet Admin?
To communicate with a CR1000 or CR3000 by TCP/IP using an NL120 or NL240, is it necessary for the data logger to have a fixed IP address?
The CR1000/CR3000 wiring panel shows four serial I/O ports on C1 to C8. Do these serial I/O ports provide the same functionality as the SDM-SIO4 module did on a CR10X or CR23X datalogger?
How many sensors can a datalogger measure?
If the message “Clock check started” is followed by the message “Clock check failed,” what does this mean?
If a device or sensor is not available for selection in the Short Cut program, how can it be added?
How many AM16/32B multiplexers can be connected to a data logger at the same time?