FAQs Frequently Asked Questions About our Products and Solutions

Submit an enquiry Submit an enquiry

All FAQs (1824 total: showing 1421-1440)

What is the preferred method for punching a clean hole through the bottom of an enclosure?
Can just the backplate of an enclosure be purchased?
Does the enclosure have a mounting bracket inside to mount the datalogger?
How often should the fuel temperature and moisture dowels be replaced?
Where is there a picture with part numbers for the fuel moisture sensor, fuel temperature stick, temperature probe, and mounting stake?
Is it possible to make a portable system that can use a TDR100, a data logger, and a TDR probe to sample on command via a switch?
How can both a TDR100 and an SDM-IO16 be connected to a single CR1000 or CR800?
Is it possible to connect more than one TDR100 to a data logger using different SDM addresses?
How can data from a TDR100 be downloaded to a laptop when only a USB port is available?
What help is available for using the TDR100 for a slope stability/rock mass deformation measurement application?
Is it possible to export the time-series data logged from a TDR100 to a computer?
How can information be sent from a TDR100 to a CR1000 for storage?
Can Short Cut for Windows write data logger code for the TDR100?
Which soil water content probes are available for the TDR100?
What items are needed to set up a TDR100 Data Acquisition System?
What is the bending limit for the cable on the 110PV-L?
Using Short Cut, is the 110PV-L configured as a half bridge, 4-wire? If so, how is the resistance calculated, and what needs to be done so that the correct temperature range will be produced?
What would indicate there is an issue with a 110PV-L?
How can a data logger be programmed to use a 110PV-L?
Can the 110PV-L be submerged?

Previous Next