FAQs Frequently Asked Questions About our Products and Solutions

Submit an enquiry Submit an enquiry

All FAQs (1824 total: showing 1461-1480)

What does the “Warning: Internal data storage memory was reinitialized” message mean?
How are raw readings produced from half-bridge measurements different between data loggers?
Where can CR1000 processor usage information be found?
What is a skipped system scan?
Why do the PPPOpen and PPPClose commands run so frequently?
Can a data logger be used for logging binary data and hexadecimal data?
Is it possible to use LoggerNet RTMC while a data logger is collecting data from a serial sensor?
How long can the cables be between networked data loggers?
Can two of the same sensor be wired to the same COM port on a data logger, with each sensor sending separate data files to the data logger?
Using RTMC Pro, is there a way to set up email alerts for a complete data logger failure?
Is there a GPS interface that can be used to keep a data logger synchronized with GPS time?
If an RF modem is used to communicate with a data logger and a PC running LoggerNet, but the modem baud rate is one third of the data logger baud rate, is that a problem?
Why might a data logger refuse having a file uploaded to it?
Is there a free software package that allows the generation of programs that can sample data on the RS-232 or COM port of the data logger?
If a data logger OS has not been upgraded in a long time, can the most current OS be downloaded, or do the upgrades need to be done incrementally?
Can two data loggers be connected over the RS-232 port, or do they need to use the COM ports to connect?
How often is the lithium battery voltage measured by the CR1000?
If a data logger has not been used in a while and the internal battery is low, will the battery recharge if the data logger is connected to a power supply? Or does the battery need to be replaced?
Is data lost when the data logger battery runs out of power in the field or is disconnected, and a “table definitions out of date” error message appears upon powering up?
Which CRBasic instruction is used to activate the 7321 relay?

Previous Next