All FAQs (1824 total: showing 901-920)
- Is it possible to measure the absolute temperature with an accuracy of 0.01°C using the FW05? Or do the thermocouple output error and the thermocouple voltage error inhibit such accuracies?
- How is sensible heat flux measured using a CSAT3/3A/3H and an FW05?
- To measure sensible heat flux using the eddy-covariance technique, which fine-wire thermocouple should be used?
- How can the pulse output of a 03101-L be converted to a 4 to 20 mA output?
- If a cup breaks off the 03101-L, can the cup be replaced, or is a new sensor needed?
- What might cause a 03101-L to produce a signal that is not high enough to be registered by the magnetic pickup?
- How is the 03101-L, with its offset fitting and strain relief, mounted to the conversion kit?
- Can the 03101-L be installed in a position that is tilted to the horizontal?
- Is a device, such as the COM320, necessary for initiating a call when the measured parameters fall out of a specified range?
- Can dual communication modes be run on a single CR1000 using a COM320 and an NL120?
- Can a CWS900-series interface make thermocouple measurements?
- How many CWS900-series interfaces can be put inside an enclosure, such as the ENC10/12, without causing interference issues?
- Does the use of a CWS900-series interface require direct line-of-sight?
- Does PC200W allow adding two different sensors to a multiplexer? If so, how?
- How can control ports be configured so that they can be toggled using the port dialog in PC200W?
- Does PC200W come with device configuration software, or is LoggerNet needed?
- What is the difference between PC208W and PC200W?
- Can LoggerNet and PC200W run at the same time on the same computer?
- What do “serial port open failed” and “permission denied” error messages mean?
- Does the “delete datalogger” function on the PC200W delete stored data on a data logger, a program, or both?
Previous
Next