Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Can I use P_LL port of CR300 as a status input?


Italo Dec 14, 2018 04:13 AM

Can I use it to connect a button that will change the status (off to on when pressed) momentary?


aks Dec 14, 2018 12:39 PM

You can use the P_SW (switch closure) port for that purpose, PILL is a low level ac four counting pulses.

Log in or register to post/reply in the forum.