Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

Using a COM320 for Modbus.


nitrogen Mar 9, 2019 03:26 AM

Are there any tricks required to get this configuration working?

Basically our CR800 program includes voice functionality which works, and we assumed that pressing 9 to enter data mode would then allow our modbus registers (which are set up on the "Com320" port using the ModbusSlave command) to be accessed from a remote device. Unfortunately, the system doesn't seem to respond.

Log in or register to post/reply in the forum.