Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.

Log in or register to post/reply in the forum.

RS232 tilt meter connect to CR1000

ashock Aug 21, 2021 05:53 AM

Hi there,

i have a sensor output with RS232

I need to send the command like "“get-x&y" and the respone should be the result of tilt meter"123.222,123,333" (in degree unit)


could anyone advise how should i do? how can i connect to CR1000

thank you so much.

Nico Aug 24, 2021 09:46 AM

See CR1000 manual, section 11.8 Serial I/O (starts on page 244 in my pdf version which is Rev9/09)
Post again when you run into problems?

Or you get lucky and someone that reads this forum and has got this sensor connected and is willing to share his code replies at some point ;-)

ashock Aug 26, 2021 12:49 AM

Dear Nico,
thank you for your information, i will try to do it.

Log in or register to post/reply in the forum.