Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

PT100 with CR1000


Test123 Aug 21, 2009 05:12 PM

Hello to all,

I want to connect 8 Pt100 (3wires) to CR1000 for temperature registration.

1) is it possible 8 Pt100 with one CR1000? if no what will be max number?

2) Is There any wiring diagram for multi temp. sensor connect to cr1000

3)Must I use for every PT100 one 4WPB100 (what is basically 10k and 100 ohm presition resistors)

4) can someone help me with the programming?

5) what is the procedure to calibrate all the sensors?


Thanks for fast reply

Best regards


Dana Aug 21, 2009 05:51 PM

Short Cut (SCWIN - http://www.campbellsci.com/scwin) program generator supports programming of the PT100 using a 3 wire or 4 wire terminal input module from CSI. Support is available only in the "CSL Sensor support" mode for SCWIN -- from the main menu select Settings | Sensor Support | Campbell Scientific Ltd. The sensor tree will repopulate and the two PRT measurements will be listed under the Temperature sensor branch.

CSL also has a manual on their web site:

http://www.campbellsci.co.uk/index.cfm?id=324

Regards,

Dana


Test123 Aug 21, 2009 08:55 PM

for using only the CR1000 (with no multiplexer) how much PT100 (with 3wires) in 4 wire bridge configuration can be hooked on it?

Please i need more information.


Thanks for you reply.


Regards


IslandMan Aug 22, 2009 10:45 AM

Using ShortCut as described by Dana, you can connect all 8 of your PT100 sensors to the CR1000 using the 3WHB10K module from Campbell Scientific. If you use the 4WPB100 you can only connect 4 of your PT100 sensors.
If you give me your email address I'll email you the ShortCut file which will have all the info you need to accomplish your task, including the wiring and programming.

IslandMan


Test123 Aug 22, 2009 11:05 AM

ahmedb@elscolab.com

Thanks very much Islandman


wuenus Dec 7, 2011 02:45 PM

IslandMan:

I hava the same problem of Tes123, i can´t connect more of 3 PT100 by shortcut.

i have a CR1000 Datalogger and i try use half bridge 3 wire.

you can send me the program?

thanks

n.huenufil@gmail.com


LoggerSupportNeeded Aug 27, 2020 12:34 PM

Hi there,

Can I get a copy of the program as well, IslandMan?  I will be connecting five pt100 RTD probes to a CR1000.

My email address in nick_hopey@hotmail.ca

Thanks in advance!

Regards,

Nick


Fmoraga May 16, 2022 01:03 PM

This post is under review.

Log in or register to post/reply in the forum.