PC200W Enhancement - Added support for CR300 Series dataloggers.
PC200W Enhancement - Added the ability to configure the number of rows and columns in the Monitor Data tab.
PC200W Enhancement - Upgraded file viewer from View to View Pro.
PC200W Enhancement - Added the "Install USB Driver..." button to the EZSetup Wizard. This button now opens the new Install USB Driver dialog which uses the list of drivers available to install from DevConfig giving the user the ability to select and install a driver from the Setup Screen.
Short Cut Enhancement - Added support for the CR300 Series dataloggers, CDM-A108, and CDM-A116.
Short Cut Enhancement - Added new or updated sensor files for 05108-45 Wind Speed & Direction Sensor, CS512 Dissolved Oxygen Probe (a CSL version, there was already a CSI version), LI190R Quantum Sensor, LI200R Pyranometer, LI200RX Pyranometer, WXT520 Weather Transmitter, Sunshine Hours (for CRBasic dataloggers, Edlog dataloggers already had it).
Device Configuration Utility Enhancement - Added support for the CR300, A100, RF451, CR6-WIFI, CR6-RF451, RF407, SDM-SIO1A, SDM-SIO4A, SoilProf3, TX321, and CDM-A100 Series.
Device Configuration Utility Enhancement - Changed the settings editor panel so that a search control is used to help locate settings rather than the combo box previously used.
Device Configuration Utility Enhancement - Changed the datalogger restore wizard by adding a page that will allow the user to select the files that will be restored.
Device Configuration Utility Enhancement - Added a search control immediately above the device types list. This control will allow the user to restrict the devices shown to those whose description matches a subset of what the user typed.
Device Configuration Utility Enhancement - Added support for a fixed 76800 baud rate on all CR1000, CR8xx, CR3000, and CR6 serial ports.
Device Configuration Utility Bug Fix - Fixed a bug in the serial number view for the CD295 where the apply button had no effect because of the code that checked for needing to commit did not recognize when the serial number had changed.
Server Bug Fix - Fixed a problem in the base class for classic datalogger commands where, if the command failed because of an invalid echo and the server immediately started on another command (say an failed "F" command followed by a "G" command), there server would make no attempt to resynchronize the link with the datalogger. This would end up sending the characters for the subsequent command as if they were a part of the preceding command.
Server Bug Fix - Fixed a bug in the interpretation of the classic logger ports byte reported through the K command where the code was using a multiply operator rather than a mask operator when picking out the value for the fourth port. The result of this error was that the fourth port would be reported high if any other port was high.
Server Bug Fix - Fixed a bug, introduced in LN 4.3, where retries were no longer enabled for the classic datalogger position modem pointer (G) command.
Server Bug Fix - Added code in the BMP5 file synch operation to use a colon to separate the file spec from the drive when it is specified when requesting a directory from the datalogger. This addresses a problem where the datalogger was returning an empty file set when the drive and file name pattern were both specified.
Server Bug Fix - Changed the BMP5 implementation of the hole collect operation so that, if the response sent by the datalogger is outside the range expected by the computer, all pending holes will be considered lost and no new holes will be added. Previously, the server was assuming that the entire table could be collected as hole and the end result was that the server could get stuck in a loop where the same records were being collected over and over.